Browse Sentinel & health data

Set up the Polar Verity Sense for Sentinel

Wake the armband with its button, put it in pairing mode, and connect it to VEXA for live heart rate without a chest strap.

WebiPhoneAndroid Updated
On this page

What this does

Connects a Polar Verity Sense armband to VEXA over Bluetooth for live heart rate. Sentinel uses available physiological readings for its body-state interventions. Live HRV is not currently available through VEXA’s standard Bluetooth heart-rate path. That path reads heart rate, not validated beat-to-beat intervals; a device’s advertised R-R support does not establish VEXA live HRV support. Historical HRV can still contribute through Apple Health or Health Connect when your source and permissions provide it. Do not choose a strap on a promise of live HRV in VEXA.

Prefer to watch? The Sentinel setup walkthrough (7 minutes) shows the whole setup on iPhone and Android, from permissions to your first rule.

Before you start

Close the Polar Flow app. The Verity Sense pairs with one app at a time.

The armband has one button. Press it once to wake the device, and the LED blinks to show it is advertising. If no LED is blinking, VEXA has nothing to find.

Wear it on the upper arm, or on the wrist with the supplied strap. Snug enough that it does not slide when you move your arm.

VEXA needs Bluetooth permission on the phone. It asks the first time you scan.

The phone can stay locked with this device.

Steps

  1. Open VEXA Sentinel from the sidebar.
  2. Open the Settings tab.
  3. Under Wearable Source, choose Polar Verity Sense. The setup modal lists the same steps.
  4. Do the pairing on your phone. The web dashboard displays readings and cannot pair a device.
  1. Press the button on the Polar Verity Sense once to wake it.
  2. Check that the LED is blinking, which means it is in pairing mode.
  3. Wear it on your upper arm, or on your wrist with the strap.
  4. Close the Polar Flow app if it is running.
  5. Open VEXA, tap Home, then Sentinel, then the gear icon, then Sentinel Settings.
  6. Tap Wearable Source, choose Polar Verity Sense, then tap Scan for Polar Verity Sense.
  1. Press the button on the Polar Verity Sense once to wake it.
  2. Check that the LED is blinking, which means it is in pairing mode.
  3. Wear it on your upper arm, or on your wrist with the strap.
  4. Close the Polar Flow app if it is running.
  5. Open VEXA, tap Home, then Sentinel, then the gear icon (Settings), then Sentinel Settings.
  6. Under Wearable source, choose Polar Verity Sense, then tap the scan action.

What you should see

The wearable section shows Polar Verity Sense with the status Connected.

Start a session and the live card shows a beats-per-minute figure updating every couple of seconds, with an HRV figure in milliseconds alongside it.

If it doesn’t work

The scan finds nothing. Either the device is asleep, so press the button and look for the blinking LED, or Polar Flow is holding it, so force close Flow and try again.

It pairs and then loses the reading when you move. The band has slipped. Optical sensors need steady contact with skin, so tighten it a little and keep it above the elbow.

Readings look low or flatline. The sensor is facing away from your skin or sitting on a sleeve. Reseat it against bare skin.

Polar’s own support page for the Verity Sense is at support.polar.com.

Related

Still stuck? Email support@vexatrade.ai.